Dys has released a v2 of their popular XM series escs… the XMS30a.
The XMS30A or XM30 V2 now has built in capacitors, giving it a much smaller footprint. They also added a slim heat sink to help dissipate the heat from the massive current draw it can handle. The XM30 has the same motor solder pads to help make installation a breeze, and for super clean builds. Designed for the high KV motors used in today’s FPV racing scene, these ESCs are king right now.
Input voltage: 3-6s Lipo
Type: BLHeli 14.4 Bootloader & Firmware
Silabs F396 Microprocessor
MOS 7440 driver
XM30 series ESC is the upgraded version of the SN series with advanced processor, a basic frequency up to 50MHz, and faster overall processing capacity to better support high KV motors
Designed for quick multi-rotor throttle response
Twisted pair cable is used to deliver throttle signal, reducing signal crosstalk while further stabilizing copper wire transmission
New miniaturization and ultra-low resistance MOSFET, powerful flow resistance, and professional MOS Drive chips improve efficiency
Newly designed PCB board improves impact resistance.
Sub-miniaturization design reduces weight while still providing a high performance filtering capacitor
Refresh rate of throttle signal up to 500Hz, compatible with all modern flight controllers, including the Naze32 Rev6 and SP Racing F3
Ultra-high speed Oneshot125 with 3000Hz refresh rate provides quick, smooth throttle response
Fully programmable via USB port, with two-way and 3D modes for high speed racing and acrobatics.